Santec VTC-8120WDP User Manual page 43

Bedienungsanleitung / User manual
VTC-8120WDP / VTC-8122WDP / VTC-8320WDP / VTC-8322WDPU
VTC-8320WDP and VTC-8322WDPU: Call-up the G-sensor OSD menu:
On the backside of the camera you will find a mini-joystick.
Press it upwards for approx. 5 seconds and the G-sensor OSD will open. You may now
adjust the G-sensor and the illuminated logo and side strip.
OSD adjustments are made by navigating with the mini-joystick.
Language:
By moving the mini-joystick left/right, you can switch between German and English.
Mode:
The mode is fix.
Sensitivity:
The sensitivity can be set for the installation surrounding: Outdoor standard, Outdoor intense,
Indoor standard, Indoor intense.
Intruder:
The sensitivity can be set for the installation surrounding, e.g. cause by a hit: Standard, High.
Alarm duration:
You can set the duration how long the notification should be displayed and how long the
relay contact should be active: OFF, 5 / 10 / 15 / 30 seconds, 1 / 2 / 5 / 10 / 20 / 30 minutes.
Light:
You can define whether the side strip and the logo should be illuminated or not:
Transient:
Always:
Water glass (water level):
This is a tool to assist with the camera installation: ON, OFF.
If the water level should be used, the alarm duration has to be set to OFF (see above) and
the electronic water level has to be set to ON.
Exit:
Exit the OSD menu and save the adjustments.
_________________________________________________________________________________
The illumination lights up only briefly when the camera is switched on.
The illumination is always onl
- 43 -