Connecting The Sonar Display To The Trolling Motor - MotorGuide Xi5 Owner's Manual

Section 3 - Product Installation, Wiring, and Battery Information
2. Connect the battery cables to the battery or plug in the battery cable to a power source. Within ten seconds of connecting
the battery cables to their terminals, press and hold the left arrow button and right arrow button on the handheld remote
simultaneously.
3. Listen for a multitone beep, which indicates that the receiver has stored the electronic serial number.
a
e

Connecting the Sonar Display to the Trolling Motor

NOTE: This procedure applies only to models equipped with integrated sonar.
This sonar display connection procedure applies to trolling motor models with internal sonar that offer built‑in 200/83 kHz sonar
transducers compatible with Eagle, Garmin, Humminbird, Lowrance, and Vexilar brand sonar displays. For compatibility with
other sonar units, refer to www.motorguide.com.
The trolling motor is equipped with a Lowrance 6‑pin plug. Adapters are available to connect other brands of sonar displays to
the trolling motor. Match the cable connector to the sonar port on the back of the sonar display. Power up the unit to ensure
that the sonar cable is connected securely.
Transducer adapter cables available from MotorGuide
Lowrance 6‑to‑7‑pin adapter
Garmin 6‑pin adapter
Vexilar 3‑pin
Humminbird 7‑pin
Page 16
b
c
d
51842
a
b
53441
a - + button—increase speed
b - Propeller button—propeller on/off
c - Right arrow button
d - – button—decrease speed
e - Left arrow button
a - Harness—to nose cone sonar
b - 6‑pin Lowrance plug—to sonar display
Part Number
8M4000386
8M4001961
8M4001960
8M4001962
90-8M0082949 JULY 2013
eng