1.
Remove the four screws from the back of the handheld remote. Remove the back cover.
a
a
a
2.
Remove the old battery from the battery holder.
3.
Insert the new battery with the positive (+) side facing the positive (+) end of the battery holder.
4.
Replace the handheld remote back plate and install the four screws. Ensure that the rubber seal is positioned correctly
between the two halves of the handheld remote. Tighten the screws securely.
Service Assistance
Your satisfaction with your product is very important to us. If you have a problem or question about your motor, contact your
dealer or any certified MotorGuide Service Center. For more service assistance information, refer to Section 1 ‑ Warranty
Information.
90-8M0082949
JULY 2013
eng
a
a -
Screws (4)
51837
a -
Negative (–) end of battery holder
b -
Battery
c -
Positive (+) end of battery holder
a
d -
Rubber seal
b
c
d
51839
Section 6 - Owner Service Assistance
51838
Page 33