Table of Contents
Advertisement
Quick Links
OUTDOOR FIREPLACE MANUAL
Standards: CSA 4.96 US 2nd Edition, CGA CR97-003, CGA 2.17-M91
Owner’'s Operation and Installation Manual
IMPORTANT: Read all instructions
carefully before starting installation.
Failure to follow these installation
instructions may result in a possible
fire hazard and will void the warranty.
If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury, or
loss of life.
-Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
-An LP-cylinder not connected for use shall not be stored in the
vicinity or this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor’'s phone.
Follow the gas supplier’'s instructions.
• If you cannot reach your gas supplier, call the fire department.
-Installation and service must be performed by a qualified installer,
service agency, or the gas supplier.
This manual must be used for installation and retained by the homeowner for
operation and maintenance. Save this manual for future reference. Please contact
your dealer for any questions or concerns.
2340 Logan Ave., Winnipeg, MB, Canada, Phone: (204) 632-1962 ––Printed in Canada- PART #42OFP-MAN
Models: OFP42N, OFP42LP, OFP42NS, OFP42LPS
Certified For USA & Canada
Outdoor Gas Fireplaces
Installer
Leave this manual with the appliance.
:
Consumer
Retain this manual for future reference
:
Warning
Warning
Improper installation,
adjustment, alteration,
service, or maintenance
can cause injury or
property damage. Read
the installation, operating
and maintenance
instructions thoroughly
before installing or
servicing this equipment.
Warning
DO NOT LEAVE
FIREPLACE
UNATTENDED WHEN
IN USE
Warning
FOR OUTDOOR USE
ONLY.
Warning
DO NOT USE FOR
COOKING.
Warning
The OFP42N and OFP42LP
Fireplace are to be used only
with the Logs/Rock Kits as
specified in this manual. Do
not burn wood or other
materials in this appliance.
July 9, 2010
Advertisement
Table of Contents
Related Manuals for Kingsman OFP42NS
Summary of Contents for Kingsman OFP42NS
- Page 1 OUTDOOR FIREPLACE MANUAL Models: OFP42N, OFP42LP, OFP42NS, OFP42LPS Certified For USA & Canada Standards: CSA 4.96 US 2nd Edition, CGA CR97-003, CGA 2.17-M91 Outdoor Gas Fireplaces Owner’’s Operation and Installation Manual Installer Leave this manual with the appliance. Consumer Retain this manual for future reference...
-
Page 2: Table Of Contents
Table of Contents Table of Contents…………………………………………………………………………………………………………………………... Warnings, Installations and Operations…………………………………………………………………………. Operations and Maintenance Instructions……………………………………………………………………. Installation Regulations………………………………………………………………………………………………………………. Installation Requirements for the Commonwealth of Massachusetts…… Pre-Installation Questions and Answers…………………………………………………………………….. Fireplace Dimensions and Framing Specifications………………………………………………. Installation Clearances Minimum Wall and Ceiling Clearances………………………………………………………… Mantel Clearances…………………………………………………………………………………………………….. Mantel Clearances- Side Walls…………………………………………...…………………………. -
Page 3: Warnings, Installations And Operations
OFP42N/OFP42LP Warnings, Installations and Operations WARNING FOR SAFE INSTALLATION AND OPERATION OF YOUR GAS FIREPLACE PLEASE NOTE THE FOLLOWING: Models OFP42N/OFP42LP are for outdoor use only. This appliance MUST NOT be used for cooking. This appliance shall be used ONLY outdoors in a well-ventilated space and shall NOT be used inside a building, garage, or any other enclosed area. -
Page 4: Operations And Maintenance Instructions
Gas fired appliances may be used only for supplemental heat and/or decorative purposes and under no circumstances shall they provide a primary heat source. OFP42N/OFP42LP Operations and Maintenance Instructions For safe installation and operation note the following: •• The Burner/Log Assembly has been engineered and permanently adjusted for proper flame control. ••... -
Page 5: Pre-Installation Questions And Answers
OFP42N/OFP42LP Pre-Installation Questions and Answers... -
Page 6: Fireplace And Framing Dimensions
OFP42N/OFP42LP Framing Specifications -Fireplace and Framing Dimensions- *Attention: Top & Rear Standoffs must be folded into position & fastened with Screws before installation. (Dimensions allow for ½”” in front of framing tabs for finishing materials.) Framing Clearances to Fireplace and Standoffs(Unless otherwise noted): Bottom: 0””/ Sides: 0””... -
Page 7: Mantel Clearances
OFP42N/OFP42LP Installation Clearances Warning Carefully follow the instructions below. This will ensure safe installation. • Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. -
Page 8: Clearance Specifications
Clearance Specifications 42OFP 2in……………………. Clearances above grade, veranda, porch, 3ft (USA)………….. Clearance to service regulator deck or balcony. 6ft (Canada) vent outlet and electric service. 12in…………………… Clearances to window or door that may be 9in (USA)…………. Clearance to non-mechanical air opened, or to permanently closed window. -
Page 9: Gas Line Installation
OFP42N / OFP42LP Gas Line Installation This gas appliance should be installed by a qualified installer in accordance with local building codes and with current CAN/CGA - B149.1 or .2 installation codes for Gas Burning appliances and equipment in Canada and the National Fuel Gas Code ANSI Z223 in the U.S.A. - Page 10 OFP42N/OFP42LP Installing Brick Panels Installing Brick Panels 1. Remove Brick Clips and Screws from inside Firebox Top. Remove Log Support. Do not discard these items. 2. Place Rear Brick Panel up against the back of the Firebox. 3. Tilt and slide Side Brick Panels into position in the sides of the Firebox.
-
Page 11: Installing Stainless Steel Surround
OFP42N/OFP42LP Installing Stainless Steel Surround -Part Number OFP42SS- A Stainless Steel Surround is available as an option for the OFP42N/OFP42LP. (Install before finishing with decorative material on facing of enclosure.) Part 1: Preparing the Fireplace 1. Remove the 2 DT Screws inside the Firebox Top and remove the Deflector Hood from the top of the unit. -
Page 12: Log Placement
LOGF37 INSTALLATION FOR OFP42 #1: 1 Bag of Small 1/4”” Lava Rock - Supplied with Unit #2: 1 Bag of Large 3/4" Lava Rock –– Supplied #3: LOGF37 –– Outdoor 7 Piece Burnt Oak Step #1 –– Place 1/4”” Lava Rock onto and around outer Step #2 ––... -
Page 13: Mq Rock Setup
MQROCK Set-up OFP42 Marquis (MQ) products are available through Marquis Dealers. Parts List #1: 1 Bag of Small 1/4”” Lava Rock –– Supplied with Unit #2: MQROCK 2 or 3 –– Box of 30 Rocks MQROCK 3 shown below) #3: MQG10W or MQG10B –– Decorative Glass White or Black (Not Shown) Do NOT use any materials other than those supplied or specified for this fireplace. -
Page 14: Parts List
MQG10(W-B) and MQROCK Set-up OFP42 Marquis (MQ) products are available through Marquis Dealers. Parts List #1: 1 Bag of Small 1/4”” Lava Rock –– Supplied with Unit (Not Used for this Set-up) #2: MQROCK 2 or 3 –– Box of 30 Rocks MQROCK3 shown below) #3: MQG10W or MQG10B ––... -
Page 15: Lighting Instructions
OFP42NG/OFP42LP Lighting Instructions 1. Remove Front Panel in order to access Igniter and valve controls. (To remove Access Panel, simply lift upward, and then pull forward.) 2. Refer to Millivolt Lighting Instructions below. Recommended Maximum Lead Length (Double Wire) When Using Wall Switch Wire Size Max. -
Page 16: Burner System Maintenance
OFP42NG/OFP42LP Burner System Maintenance It is recommended to annually inspect and clean the Burner System to prevent malfunction and / or sooting. This operation should be performed by your dealer or a qualified technician. -CAUTION- Before servicing the burner system ensure that the gas supply is turned OFF and disconnect all electrical connections to the appliance. -
Page 17: Gas Conversion -Burner-Part A
OFP42N / OFP42LP Gas Conversion -Burner-Part A Warning! This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’’s instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion, or production of carbon monoxide may result in causing property damage, personal injury or loss of life. -
Page 18: Gas Conversion -Valve- Part C
OFP42NG/OFP42LP Gas Conversion ––Valve-Part C... -
Page 19: Troubleshooting The Gas Control System
OFP42N/OFP42LP Troubleshooting the Gas Control System NOTE: Before troubleshooting the gas control system, be sure external gas shut off is in the ““ON”” position. Problem Possible Causes Corrective Action Spark igniter will not Defective or misaligned electrode at Check for spark at electrode and pilot: if no spark and electrode light pilot. -
Page 20: Electronic Spark Assist
OFP42N / OFP42LP -Electronic Spark Assist- (Part Number OFP42SA) A Battery powered module is available to assist in lighting the pilot burner. See below for installation. - Page 21 OFP42WC -Weather Cover- An optional Weather Cover is available to protect the inside of the unit when not in use. Assembly Instructions 1. Insert Carriage Bolts through handles and into front of Fireplace Cover. 2. Place washer and nut onto bolts on the back side of the Fireplace Cover.
-
Page 22: Parts List
OFP42N Outdoor Fireplace Black 55,000BTU OFP42WCSS Weather Cover (Stainless Steel) OFP42LP Outdoor Fireplace Black 55,000BTU OFP42WCBL Weather Cover (Black) OFP42NS Outdoor Fireplace Stainless 55,000BTU OFP42-P642 Safety Switch (Weather Cover) OFP42LPS Outdoor Fireplace Stainless 55,000BTU OFP42SA Spark Assist Replacement Burner Assembly... -
Page 23: Limited Warranty
OFP42N/OFP42LP -- Limited Warranty...