Log Set Installation - Regency bellavista B36XTCE Owner's Manual

INSTALLATION
Read the instructions below carefully and refer to the images. If the
logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can
alter the unit's performance which is not covered under warranty.
Log Kit #576-930 contains the following pieces:
A Right Front Log
B Left Front Log
C Top Middle Log
D Top Right Log
E Rear Log
902-156 Lava Rocks
902-179 Vermiculite
946-669 Platinum Embers
(supplied w/packaged manual)
E
B
1) Carefully remove the logs from the packaging and unwrap them. The
logs are fragile, handle with care - do not force into position.
44

LOG SET INSTALLATION

Installation of Optional Panels must be completed before installing the log set.
C
A
2) Spread vermiculite along the base of the fi rebox.
3) Place Log E on the rear log support pins with the fl at side to the
back.
D
4) Place Log B on the front left side of the burner. Position the notch
on the bottom left side of the log into the left side of the grate.
Slide Log B back towards Log E until the fl at surface on Log B rests
up against the tabs on the burner and grate - this maintains a
necessary gap between Logs B & E.
B
Note: See fi nal positioning of Log B on next page.
Vermiculite
E
Notch
Regency B36XTCE Gas Fireplace
Tabs on
burner &
grate