Play With Headphones; Play With The Pedals - GEM GPS3600 Owner's Manual

• Adjust the general volume with the MASTER
VOLUME slider.
A comfortable level is around two thirds of
the slider's travel distance.
If you are using external amplification, better
results are obtained by adjusting the volume
with mixer or amplifier controls rather than
lowering the volume of the instrument.

PLAY WITH HEADPHONES

• Plug a set of headphones into the PHONES
1 jack.
The headphones jack panel is located on the
left side of the instrument, under the key-
board. Inserting the headphones plug into
the PHONES 1 jack excludes the internal
speakers to allow you to play in total silence
without disturbing others in the same room.
Plugging into the PHONES 2 jack does not
exclude the internal speakers.
Use the Master Volume slider to adjust the
headphones volume.

PLAY WITH THE PEDALS

The group of three pedals, denoted Ped 1, Ped
2, Damper, provide preset functions. The default
configuration of the pedals is as follows:
• Ped1 =
• Ped2 =
• Ped3 =
The pedals are function assignable and can be
independently enabled or disabled to react with
the keyboard sections of a Preset.
The SOFT and SOSTENUTO pedals are switch
action controls.
The DAMPER pedal can be programmed as a
Continuous (graduated levels) or Switch action
(on/off) pedal.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
1•16 Quick Guide
Soft
Sostenuto
Damper (sustain)
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4
5
SOFT
Note: If the Pedals do not appear to operate,
check that the cable running from the pedal
groups is properly connected to the PEDALS jack
on the rear panel of the instrument.
○ ○
SOSTENUTO
DAMPER