Tracks/Splits - GEM GPS3600 Owner's Manual

Tracks/Split
Here you can program the parameters exclusive
to the tracks, such as Section Transpose, Detune,
Polyphony priority, Velocity. These parameters
would affect any sound you decide to assign to
the tracks being programmed.
TRANSPOSE (F1)
Here you can change the pitch of the sound in
half tone steps, within a maximum range of 60
steps up or down.
Assignable values: –60...0...+60.
MASTER TRANSPOSE ENABLE/DISABLE (F2)
Usually you will want to leave this set to ON. It
confirms that this sound will be affected by the
TRANSPOSE buttons on the front panel. In some
situations, for example, when using drum kits, you
may not want the track to be shifted. In this case,
set this function to OFF (default setting).
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
3•20 Reference Guide
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
DETUNE (F3)
This allows you to adjust the fine pitch of the
sound in steps of 1/64th of a semitone.
Assignable values: - 63...0...+63 .
RANDOM PITCH (F4)
This function automatically applies a little detuning
to the sound each time a new note is played. The
amount by which it detunes the note is limited by
the value you select. At maximum value, (7), this
automatic detuning may be as much as a half step
sharp or flat.
Assignable values: 0 (no effect) ... 7 (maximum
randomness) .
TOUCH SENSITIVITY (F5)
This function enables or disables the tracks of
○ ○