Epson EB-G6170 User Manual page 98

List of Functions
Submenu
Operation Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
High Altitude Mode: Set to On when using the projector
above an altitude of 1,500 m.
BNC Sync Termination: Set the termination for the signal
from the BNC port. This should usually be set to Off. Set to
On when analog (75Ω) termination such as for switchers is
necessary.
Remote Control Type: You can select Normal or Simple
depending on the type of remote control.
Set this item to Normal to use the remote control provided
with this projector. When Simple is selected, you can use
the remote control provided with other Epson projectors to
operate this projector. This is useful if you want to use a
remote control that you are already familiar with to operate
the projector.
However, you cannot use the remote control provided with
this projector if this is set to Simple. Make sure that the
setting is correct because, if the projector is mounted on the
ceiling or somewhere hard to reach, changing it back to
Normal may be difficult. Additionally, you cannot use the
functions that are not equipped with this projector or the
remote control which you use.
Inv Direction Button: Set this to On when the projector is
installed on a ceiling.
Function Submenu
Startup Source Search: Set whether or not (On/Off) to
automatically detect the image signal being input when the
projector is turned on.
A/V Mute Release: (This item cannot be set if User's Logo
Protection from Password Protection is set to On.
s p.83)
When set to A/V Mute, you can only release A/V mute by
pressing the [A/V Mute] button (or by sending an A/V
mute Off command).
When set to Any Button, A/V mute is released when any
operation is performed on the projector.
s "Hiding the Image and Sound Temporarily (A/V Mute)"
p.74
Beep: When this is set to On, the confirmation buzzer
beeps to notify you that the power turns on or off, or
cooling down is finished.
Lens Type: Select the model number for the lens you are
using.
Instant Off: When set to Enabled, the projector goes into
standby status in approximately three seconds after Power
Off. If you turn the power on immediately after turning it
off, command communication may be cut off. To stabilize
command communication, set this to Disabled. When set to
Disabled, the projector goes into standby status in
approximately 75 seconds after power off.
Date & Time: Make system time settings for the projector.
s "Setting the Time"
98
Function
p.35