Epson EB-G6170 User Manual page 97

List of Functions
Submenu
Display You can make settings related to the projector's display.
Menu Position: Select the position to display the menu on
the projected screen.
Messages: When set to Off, the following items will not be
displayed.
Item names when the Source, Color Mode, or Aspect is
changed, messages when no signal is being input, and
warnings such as High Temp Warning.
Display Background
to Black, Blue, or Logo when no image signal is available.
Startup Screen
projection starts.
A/V Mute
the [A/V Mute] button is pressed to Black, Blue, or
Logo.
Standby Confirmation: (This is unavailable when the
Remote Control Type is set to Simple.) When set to On
(default), a confirmation message is displayed asking
whether or not to turn off the power when the [t] button
is pressed. Press the [t] button again to turn the power
off.
Air Filter Notice: You can set whether or not (On/Off) to
enable Air Filter Notice. When this is set to On and a clog
in the air filter is detected, the message is displayed on the
screen.
Screen: (This setting is unavailable when projecting images
from a computer over a network.) Set the aspect ratio and
position of the projected screen according to the type of
screen being used.
s "Screen Settings"
Panel Alignment: Correct color misalignments (red and
blue) in the screen.
s "Panel Alignment"
Color Uniformity: Adjusts the color tone balance for the
whole screen.
Function
*
: You can set the screen background
* : Set to On to display the User's Logo when
*
: You can set the screen displayed when
p.27
p.149
Submenu
s "Color Uniformity"
User's Logo * You can change the user's logo that is displayed as a
background during Display Background, A/V Mute, and so
on.
s "Saving a User's Logo"
Projection Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [A/V Mute] button for about five seconds.
FrontWFront/Ceiling
RearWRear/Ceiling
Set this parameter according to the installation status of the
Direction
projector.
s "Installation Settings"
97
Function
p.150
p.76
p.26