Connecting A Lan Cable; Connecting An Hdbaset Transmitter - Epson EB-G6170 User Manual

Connecting Equipment
a
• Make the following settings to output image and audio even when the projector is in standby mode.
Set Standby Mode to Communication On.
s Extended - Standby Mode
Set A/V Output to Always On.
s Extended - A/V Settings - A/V Output
• Only analog RGB signals from the Computer port or BNC port can be output to an external monitor. You can set which signals to output in Monitor
Out.
s Extended - A/V Settings - Monitor Out
• When the audio cable jack is inserted into the Audio Out port, audio stops being output from the projector's built-in speakers and switches to external
output.

Connecting a LAN Cable

Connect a LAN port on network hubs or other equipment to the projector's LAN port with a commercially available 100BASE-TX or 10BASE-T LAN
cable.
By connecting a computer to the projector over a network, you can project images and check the status of the projector.
a
To prevent malfunctions, use a category 5 or higher shielded LAN cable.

Connecting an HDBaseT Transmitter

Connect the optional HDBaseT Transmitter with a commercially available 100BASE-TX LAN cable.
p.96
p.96
p.96
LAN
44