Batch Setup; Setup Using A Usb Flash Drive; Saving Settings To The Usb Flash Drive - Epson EB-G6170 User Manual

Batch Setup

Once the Configuration menu content has been set for one projector, you
can use it to perform batch setup for multiple projectors (batch setup
function). The batch setup function is only for projectors with the same
model number.
Use one of the following methods.

• Setup using a USB flash drive.

• Setup using EasyMP Network Updater.
This document describes how to use the USB flash drive.
a
• The following content is not reflected by the batch setup function.
- The Network menu settings (except for the Mail menu and the
Others menu)
- Lamp Hours and Status in the Info menu
• Perform batch setup before adjusting the projected image.
Adjustment values for the projected image, such as Geometric
Correction are reflected by the batch setup function. If batch setup is
performed after adjusting the projected image, the adjustments you
made may change.
• By using the batch setup function, the registered User's Logo is set
for the other projectors. Do not register confidential information and
so on as the User's Logo.
Caution
Performing batch setup is the customers responsibility. If batch setup fails due
to a power failure, communication error, and so on, the customer is responsible
for any repair costs incurred.
Setup Using a USB Flash Drive
This section explains how to perform batch setup using a USB flash drive.
a
• Use a FAT format USB flash drive.
• The batch setup function cannot be used by USB flash drives that
incorporate security functions. Use a USB flash drive that does not
incorporate security functions.
• The batch setup function cannot be used by USB card readers or
USB hard disks.

Saving settings to the USB flash drive

a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the USB flash drive to the projector's wireless LAN unit
port.
"Installing the Wireless LAN Unit"
s
115
p.46