Shared Parallel Printer Installation - North Star DIMENSION Service Manual

PERIPHERAL EQUIPMENT INSTALLATI(I
(cont.) Shared Printers
Parallel
The back panel of the central module has one
Printer
connector which you may use for attaching a
Installation
parallel printer. This connector is labeled
"Parallel 1."
Procedure :
Shared Parallel Printer Installation
1. Connect one end of a parallel printer cable to the parallel
port connector ("Parallel 1") on the rear panel of the
central module. Firmly fasten the cable using the screws
attached to the cable connector.
2. Connect the other end of the parallel printer cable to the
port connector of the parallel printer. Firmly fasten the
cable using the screws attached to the cable connector.
3. Connect the printer main power cable to a 115VAC (or 230VAC)
wall outlet which is commonly fused and grounded to the
central module.
This completes the installation procedure for a shared
parallel printer.
Technical Manual 1-25