North Star DIMENSION Service Manual page 22

SYSTEM HARDWARE INSTALLATION
Central Module (cont.)
Procedure :
Central Module Installation and Configuration
9. Position the expan-
sion RAM circuit
board over the two
plastic standoffs
and workstation
board connector.
Press the expansion
RAM circuit board
in place. Repeat
steps #7 through #9
for each expansion
RAM circuit board.
10. There are thirteen
numbered , sheet-
metal plates
attached to the rear
panel of the central
module. The upper
edges of the plates
are fastened with a
screw.
Count the number of
workstations you
plan to install,
and, beginning with
plate #1, consecu-
tively remove as
many of the plates
as you have work-
station circuit
boards to install.
1-10 Technical Manual