North Star DIMENSION Service Manual page 176

SUBASSEMBLY REMOVAL
8087 Board
Introduction
Use this procedure for removing an 8087 board from a
workstation board.
Procedure: 8087 Board Removal
1. Remove the workstation board from the central board. Lay the
workstation board on a flat, well-supported surface.
2. After unlocking the plastic standoffs that connect the two circuit
boards, gently pry first one edge and then an opposite edge of the
8087 board away from the workstation board.
CAUTION
Be very careful not to bend the pins of plug P1 on
the 8087 board.
This concludes the procedure for removing an 8087 board.
4-4 DIMENSION Service Manual