North Star DIMENSION Service Manual page 23

SYSTEM HARDWARE INSTALLATION
(cont.) Central Module
Procedure : Central Module Installation and Configuration
11. Beginning at posi-
tion # 1, install the
workstation circuit
boards in consecu-
tive slots. Seat
the circuit board
edge connectors and
mounted sheet-metal
plates in the slots
of the bus circuit
board and central
module rear panel.
Note : Be careful
not to bend the
sheet-metal plates
when inserting them
in the central
module rear panel
slots.
12. Fasten the workstation circuit boards in place using the
screws you removed in step #10.
13. Notice that there is
a thumbwheel switch
on the rear edge of
each workstation
circuit board.
Rotate each thumb-
wheel switch to a
consecutive number,
beginning with #1
in circuit board
position #1.
Note: No two
switches may be set
to the same number.
circuit board position #1
thumbwheel
switch
00
Technical Manual 1-11