North Star DIMENSION Service Manual page 175

SUBASSEMBLY REMOVAL
Workstation Board
Introduction Use this procedure to remove one or more workstation
board subassemblies from the central module.
Procedure: Workstation Board Removal
1. Remove the Phillips screw that fastens the rear edge of the
workstation board to the central module back panel.
2. Lift the workstation board straight up to disconnect it from the bus
board socket .
Continue lifting to remove the board from the central
module.
3. Repeat steps #1 and #2 for each workstation board you wish to
remove.
This concludes the procedure for removing a workstation board from
the central module.
DIMENSION Service Manual 4-3