Fixed Disk Drive - North Star DIMENSION Service Manual

SUBASSEMBLY REMOVAL
Fixed Disk Drive
Introduction
Use this procedure to remove one or more fixed disk drives
from the central module.
In order to remove the fixed disk drives, first remove the
drive mount bracket in which the drives are mounted.
Procedure: Fixed Disk Drive Removal
1. Remove the four Phillips screws that fasten the rear panel of the
drive mount bracket to the rear panel of the central module.
2. Disconnect the DC power, signal and control harnesses from the rear
of the fixed disk drive/s.
Note: If there is a spare DC power harness tie-wrapped to the drive
mount bracket, cut the tie wrap.
3. Slide the drive mount bracket toward the front of the central module
to disconnect the bracket from the central module base panel.
Lift the drive mount bracket up and out of the central module.
4. Remove the four Phillips screws that fasten the fixed disk drive to the
drive mount bracket.
5. Remove the fixed disk drive from the drive mount bracket.
This concludes the procedure for removing fixed disk drives.
4-16 DIMENSION Service Manual