North Star DIMENSION Service Manual page 121

DIAGNOSTICS
(cont.) Service Diskette #1
Test When you press [Retrn] from the configuration screen, the
Command Test Command Menu appears at workstation #1.
Menu
North Star DIMENSION System Tests -- Rev. 2.x.x
-- Test Command Menu --
0 - Test the central board only
1 - Test the complete system
2 - Run a single test ( use with menu option #9)
3 Change loop mode, now = OFF
4 - Change abort on error, now = OFF
5 - Change break on error, now = OFF
6 Change wait on break, now = OFF
7 Change loop detection , now = OFF
8 - Select loop detection pattern now = xxxxH
9 Select new test pointer now = xxxxH
A - Connect to Automated Test System
B - Display system configuration
C - Test a single workstation board ( I.D. from menu option #8)
D - Workstation character display test
E - Test all workstations
Workstation During central module testing, the following screen appears
Screen
at all workstation monitors (except workstation #1). This
screen remains unchanged at individual monitors until they
are tested.
The system is temporarily unavailable while routine
maintenance is performed. Your patience is appreciated.
Your System Manager
DIMENSION Service Manual 3-9