Tape Drive - North Star DIMENSION Service Manual

SUBASSEMBLY REMOVAL
Tape Drive
Introduction
Use the following procedure to remove the tape drive from
the central module.
In order to remove the tape drive, first remove the drive
mount bracket in which the drive is mounted.
Procedure: Tape Drive Removal
1. Loosen the four Phillips screws that fasten the drive mount bracket to
the base panel of the central module.
2. Remove the two screws that fasten the drive mount bracket to the
front panel.
3. Disconnect the DC power and signal harnesses from the rear edges of
the tape and diskette drives.
Note: If there are spare DC power harnesses tie-wrapped to the
bracket, cut the tie wrap.
4. Slide the drive mount bracket toward the rear of the central module,
and lift the bracket straight out of the central module.
5. Remove the four Phillips screws that fasten the tape drive to the
drive mount bracket.
DIMENSION Service Manual 4-17