Chapter 1 - Hardware Installation - North Star DIMENSION Service Manual

CHAPTER 1
HARDWARE INSTALLATION
Overview
This chapter explains how to install DIMENSION
computer system hardware including the central
module, its workstations and peripheral devices
such as printers.
DIMENSION computer systems may vary significantly
in complexity. A simple system might contain two
workstations and' a shared printer; a complex sys-
tem might contain as many as-twelve-workstations
with shared and local printers and modems, and
local mouse devices. Simple and complex systems
use the installation procedures found on the
following pages.
Because of the number of power cords and cables
used to connect the components of the system, you
should position the equipment before attaching
cords and cables. Begin the installation by
sketching your office area and determining where
you plan to locate the central module, worksta-
tions and peripheral equipment. Then unpack and
move the components to the locations suggested by
your sketch. After you've finished positioning
the equipment, begin using the installation
procedures to connect the components.
You'll need a small slotted screwdriver and a
medium Phillips screwdriver to complete the
installation procedures.
Technical Manual 1-1