Arctic Cat 2008 Prowler Owner's Manual page 39

NOTE: Clock memory power is supplied through the 15-amp
accessory fuse and verified during gauge "power-up" and reset. In
the event of clock memory power failure (blown fuse, etc.), the
gauge will "power-up", reset, and shut down repeatedly until clock
memory power is restored. Always check the 15-amp accessory
fuse if this gauge condition is noted.
NOTE: The engine hour meter will not activate until engine speed
exceeds 500 RPM.
2. Fuel Level Indicator - Indicates approximate amount of gasoline in the gas
tank.
NOTE: When the bottom segment flashes, approximately 3.8 L (1.0
U.S. gal.) of gasoline remains in the tank.
3. Mode Button - Shifts the digital gauge through three modes: speed/tachome-
ter, distance, and time.
NOTE: The Mode Button must be pressed and released to shift
modes. Approximately two seconds after the Mode Button is
released, the digital gauge will return to full display.
4. Set/Reset Button - In conjunction with the Mode Button, sets and resets var-
ious displays on the digital gauge. Also used to switch from speedometer
function to tachometer function on the speedometer/tachometer gauge.
5. Odometer/Trip Meter (#1 and #2) - Odometer registers the total distance the
vehicle has traveled. Trip meters can register two distances (for instance, #1
could register trip distance and #2 could register distance between stops).
The trip meters can be reset while the odometer only registers accumulated
miles/kilometers.
NOTE: To select the odometer (ODO), trip #1 (T1), or trip #2 (T2),
press the Mode Button (3) to select the distance mode; then press
the Set/Reset Button (4) to select the desired display. Hold the Set/
Reset button down to reset trip meters.
6. Gear Position Indicator - Indicates which gearshift position is selected.
7. Speed/Tach Indicator - Indicates approximate vehicle speed in mph or k/ph
when speedometer function is selected or rpm when tachometer function is
selected.
8. Speed Function Display - Displays which speed function (MPH, TACH, K/
PH) is being indicated by the Speed/Tach indicator.
��
37