Control Locations And Functions; Ignition Switch; Speedometer/Tachometer/Lcd - Arctic Cat 2008 Prowler Owner's Manual

CONTROL LOCATIONS AND FUNCTIONS

Ignition Switch

RUN position - The ignition circuit is complete and the engine can run. The key
cannot be removed in this position.
START position - The ignition circuit is complete and the starter is engaged.
When the key is released, the switch will return to the RUN position. The key
cannot be removed in this position.

Speedometer/Tachometer/LCD

1. Clock/Hour Meter - The clock function
indicates time in the 12 hour mode; the
hour meter indicates the total time the
vehicle has run and cannot be reset to
zero.
A. With the ignition switch ON, press
and release the Mode Button (3)
until the Clock/Engine Hour Meter
(1) is displayed; then (if necessary) press and release the Set/Reset
Button (4) to the clock display.
B. Press and hold the Set/Reset Button (4) until the minutes stop scrolling
and the hour display starts to scroll. Momentarily release when the cor-
rect hour is displayed; then repeatedly press and release the Set/Reset
Button (4) until the correct minutes are displayed.
NOTE: Approximately two seconds after releasing either Button,
the LCD will return to normal operation.
36
The ignition switch has three positions.
OFF position - All electrical circuits
except the accessory are off. The engine
will not start. The key can be removed in
this position.
NOTE: The accessory plugs are
powered by the battery at all times.
ATV-0056A
CF094A
��