Gas/Vent Hoses; Carburetor Float Bowl Drain; Seat Belts - Arctic Cat 2008 Prowler Owner's Manual

SEAT BELTS (if equipped)
This vehicle is equipped with lap-style seat belts for the operator and the passen-
ger. To fasten and release the seat belt properly, use the following procedure.
1. Place the seat belt across your lap as low as possible without twisting the
belt.
2. Push the latch-plate into the buckle slot until it "clicks" and latches securely.
The belt will self-tighten when the buckle is released.
Falling from a moving vehicle could result in serious injury or death.
Always fasten your seat belt securely and ensure the passenger seat
belt is properly and securely fastened prior to operating or riding in
this vehicle.

GAS/VENT HOSES

Replace the gas hose every two years. Damage from aging may not always be
visible. Do not bend or obstruct the routing of the carburetor vent hose. Make
certain that the vent hose is securely connected to the carburetor and hose holder
and the opposite end is always open.

CARBURETOR FLOAT BOWL DRAIN

Periodically, the float bowl should be drained to remove condensation. To drain
the float bowl, use the following procedure.
1. Remove both seats; then remove the center console.
Do not drain float bowl contents directly onto the engine. Gasoline is
highly flammable and could ignite. Use a hose.
2. Place an appropriate drain pan beneath the float bowl drain tube; then loosen
the drain screw and allow the gasoline and condensation to flow out.
3. Tighten the drain screw securely and properly dispose of the gasoline.
It is very important that the drain screw be tightened securely. If it is
not tightened securely, gasoline could drip onto the engine.
44
! WARNING
! WARNING
! WARNING
��