Operating Instructions
1.2 Starting or Closing This Software
This software starts automatically when you boot up the PC.
•
is displayed in the notification area while this software is running.
PC screen
Start
Note
To not start this software automatically when booting up the PC, right-click
and uncheck [Start on bootup] from the menu.
1.2.1
Starting Operation Window
Double-click
• Operation window of this software is displayed.
Note
• You can also start the operation window through the following procedures.
• From the [Start] menu, select [All Programs] → [Network Camera Recorder
with Viewer Software] → [Network Camera Recorder with Viewer Software].
• From Explorer, double-click [ncr3.exe] in the location where the software was
installed.
• These softwares cannot work at the same time. Use only a software.
• To use this software, perform the license registration.
If no license has been registered when the operation window is started,
[Register the license key] will be displayed. Follow the steps on page 10.
8
Displayed in the
notification area.
on the desktop to start this software.
notification area