Table of Contents
Advertisement
AirCard 700 Series Installation Guide
60
Information pertaining to OEM customers
The AirCard 750/775 wireless network card has been granted
modular approval for mobile applications. Integrators may use
the AirCard 750/775 card in their final products without
additional FCC / IC certification if they meet the following
conditions. Otherwise, additional FCC / IC approvals must be
obtained.
1.
At least 20 cm separation distance between the antenna
and the user's body must be maintained at all times.
2.
To comply with FCC / IC regulations limiting both
maximum RF output power and human exposure to RF
radiation, the maximum antenna gain in the PCS band
must not exceed 4 dBi for the AirCard 750 and the
maximum antenna gain in the Cellular and PCS bands
must not exceed 4.5dBi for the AirCard 775.
3.
The AirCard 750/775 card and its antenna must not be
colocated or operating in conjunction with any other trans-
mitter or antenna within a host device.
4.
A label must be affixed to the outside of the end product
into which the AirCard 750/775 is incorporated, with a
statement similar to the following:
For an end product with an embedded AirCard 750:
This device contains TX FCC ID: N7NAC750.
This equipment contains equipment certified under Can-
ada: 2417C-11897.
For an end product with an embedded AirCard 775
This device contains TX FCC ID: N7NAC775.
This equipment contains equipment certified under IC:
2417C-AC775.
5.
A user manual with the end product must clearly indicate
the operating requirements and conditions that must be
observed to ensure compliance with current FCC / IC RF
exposure guidelines.
The end product with an embedded AirCard 750/775 card
must pass the unintentional emission testing and properly
authorized per FCC Part 15 requirements.
Note: If this PC Card is intended for use in a portable device,
you are responsible for separate approval to satisfy the SAR
requirements of FCC Part 2.1093 and IC RSS-102.
2130204CEFCC
Advertisement
Table of Contents
