Table of Contents
Advertisement
Note: You must restart your PC
to complete the installation.
Rev 2.1A Jun.04
Close
9.
Click
to close the Network window and open the
Microsoft TCP/IP Properties window.
Sierra Wireless AirCard GPRS Adapter
10.
Select
Obtain an IP address from a DHCP Server
field and select
radio button.
Yes
11.
Click
to confirm that DHCP is to be used.
OK
12.
Click
to close the TCP/IP Properties window.
No
13.
Click
if prompted to restart your PC. (You must restart
your PC after the modem driver installation.)
On completion of this step, the network card driver is installed
and you can proceed to install the modem driver. Follow the
instructions in the next section.
Installing the modem driver
1.
In the Control Panel, double click the Modems icon. If the
Install New Modem wizard opens, skip to
Otherwise, proceed to
Add
2.
Click the
button to open the Install New Modem
wizard.
Don't detect my modem, I will select it from a list
3.
Select
Next
.
Have Disk
4.
Select the
d:\Drivers\WinNT\
5.
Enter
CD-ROM drive and click
Sierra Wireless AirCard GPRS Modem
6.
Verify that
Wireless AirCard EDGE Modem
Selected Ports
7.
Select the
communications port used for the network card driver
(COM 4 unless you changed it). Click
Finish
8.
Click
.
Close
9.
Click
to close the Network Properties window.
10.
If you are prompted to restart your PC, click
Otherwise restart your PC from the Start menu.
11.
When the PC restarts, re-install your Service Pack.
On completion of this step, the modem driver is installed and
you can proceed to configure the AirCard to use your account
(if it was not preactivated). See the section "Account Configu-
ration Procedures" on
Installation on Notebook PCs
Step
2.
button.
d
where
is the drive letter for your
OK
.
is displayed and click
radio button and select the same
Next
page
35.
in the Adapter
Step
3.
and click
Sierra
or
Next
.
.
Yes
.
23
Advertisement
Table of Contents
