Table of Contents
Advertisement
AirCard 755 Installation Guide
Note: The FCC defines a mobile
device as being designed for use
"in other than fixed locations and
to generally be used in such a
way that a separation distance of
at least 20 centimeters is
normally maintained between
radiating structures and the body
of the user or nearby persons."
54
•
Consult the dealer or an experienced radio/TV technician
for help
If you have purchased this product under a United States
Government contract, it shall be subject to restrictions as set
forth in subparagraph (c)(1)(ii) of Defense Federal Acquisitions
Regulations (DFARs) Section 252.227-7013 for Department of
Defense contracts, and as set forth in Federal Acquisitions
Regulations (FARs) Section 52.227-19 for civilian agency
contracts or any successor regulations. If further government
regulations apply, it is your responsibility to ensure
compliance with such regulations.
Information pertaining to OEM customers
The AirCard 755 wireless network card has also been granted
modular approval for mobile applications. Integrators may use
the AirCard 755 card in their end products that can be catego-
rized as Mobile Devices without additional FCC certification
approvals if the following conditions are met. Otherwise,
additional FCC approvals must be obtained.
1.
At least 20 cm separation distance between the antenna
and the user's body must be maintained at all times.
2.
To comply with FCC regulations limiting both maximum
RF output power and human exposure to RF radiation, the
maximum antenna gain in Cellular and PCS bands must
not exceed 4.5 dBi.
3.
The AirCard 755 card and its antenna must not be collo-
cated or operating in conjunction with any other trans-
mitter or antenna within a host device.
4.
A label must be affixed to the outside of the end product
into which the AirCard 755 is incorporated, with a
statement similar to the following:
This device contains TX FCC ID: N7NAC755
A user manual with the end product must clearly indicate
5.
the operating requirements and conditions that must be
observed to ensure compliance with current FCC RF
exposure guidelines.
Note: If this PC Card is intended for use in a portable device, you are
responsible for separate approval to satisfy the SAR requirements of
part 2.1093.
2130336
Advertisement
Table of Contents
