IBM 6151 Maintenance And Service Manual page 50

Installation Verification
The Installation Verification program compares the installed
features list created by the Loadable POST programs
to
the
configuration record on the fixed disk.
The Installation Verification program is run during installation
and setup to check all the adapters and options after shipment.
The program assumes the Diagnostic Routines were run after the
last change to the system unit. Running the Diagnostic Routines
updates the configuration record on the fixed disk.
To run the Installation Verification:
1.
Press Enter after reading the DIAGNOSTIC OPERATING
INSTRUCTIONS.
2. Choose Installation Verification on the FUNCTION
SELECTION menu.
3. If the installed features list and configuration record do not
match, follow the displayed instructions.
2-18 Service Manual