IBM 6151 Maintenance And Service Manual page 206

Step 28
1. Look at the type and slot positions you recorded, and install the
boards and adapters you removed.
2. Unplug the external power cable from the outlet.
3. If disconnected, connect all attached devices (such as expansion
unit).
4. Install the top cover. If needed see Section 4.
5. Set the power switch on the system unit to On.
6. Follow the instructions on the menus to run the System
Checkout. The TEST OPTION and the DIAGNOSTIC TEST
LIST menu will display if the configuration was changed.
Follow the instructions as they display. If needed, see page
2-17.
WERE YOU ABLE TO LOAD AND RUN THE "SYSTEM
CHECKOUT" AND DID THE "NO TROUBLE WAS FOUND"
MESSAGE DISPLAY?
NO If the same failure occurs, contact your service support
person, otherwise, go to "Problem Determination Procedure
PIC 0030" on page 3-0030-1.
YES This completes the repair.
3-0060-30 Service Manual