IBM 6151 Maintenance And Service Manual page 237

Step 9
Note: Be sure to use the Adapter Removal procedure in the IBM
RT PC 6192 Expansion Unit Hardware Maintenance and Service
manual for any adapter installed in the RT PC 6192.
1. Look at the type and slot positions you recorded, and install the
boards and adapters you removed.
2. Install any covers you have removed.
3. Set the power switch on the RT PC 6192 to On.
4. Set the power switch on the system unit to On.
5. Follow the instructions on the menus to run the System
Checkout. The TEST OPTION and the DIAGNOSTIC TEST
LIST menu will display if the configuration was changed.
Follow the instructions as they display. If needed, see page
2-17.
WERE YOU ABLE TO LOAD AND RUN THE "SYSTEM
CHECKOUT" AND
DID
THE "NO TROUBLE WAS FOUND"
MESSAGE DISPLAY?
NO If the same failure occurs, contact your service support
person, otherwise, go to "Problem Determination Procedure
PIC 0030" on page 3-0030-1.
YES This completes the repair.
(6/88) Problem Isolation Charts 3-0100-9