Engine Stop Key; Pre-Drive Inspection - Joyner JNSZ800UV-R4 Owner's Manual

Engine stop key

Before driving this vehicle, test the Engine Stop key to assure that it is operating properly. With
the engine running, turn the key counterclockwise to the "off" position for the engine to shut
down.

Pre-Drive Inspection

Perform this pre-drive inspection everyday before driving vehicle. If not performed,
serious damage to the vehicle or personal injury may result.
1. Check for Engine Oil Level. Check for transmission Oil Level. Check for leaks, add oil if
required.
2. Check the coolant. Check for leaks, add the coolant if required.
3. Check for Fuel Level. Add fuel as necessary and do not overfill. Check for leaks.
4. Check for Brakes. Depress the brake pedal several times, and then check for proper brake
pedal free play. Make sure there is no brake fluid leakage. Adjust if necessary.
5. Check the clutch cable. Assure the cable snaps back and has a smooth operation. Ensure the
clutch can operate smoothly. Adjust if necessary, or replace the clutch if necessary.
6. Check Tires. Check tires condition and pressure. The pressure on both Front and Rear tire is
30pis.
7. Check Throttle. Check for smooth operation. Ensure the throttle "snaps" back to idle.
8. Check Engine Stop key. Perform engine stop key test. Repair as necessary.
9. Check all Nuts, Bolts, and fasteners. Check wheels to see that all axle nuts and lug nuts are
tightened properly. Check and tighten all other fasteners to specified torque as necessary.
10. Check Roll Cage Bars. Ensure all protective roll cage bars are in place before operating the
UV800-R4.
11. Check Brake Light. Check for proper operation.
12. Check Wheels. Check for tightness of wheel nuts and axle nuts; check that axle nuts are
secured by cotter pins.
13. Check Steering. Check for free operation and for any unusual looseness in any area.
40