Engine Coolant - Joyner JNSZ650UV Owner's Manual

Figure 14
a. Put the vehicle on the level ground.
b. Shut down the engine, put a collecting oil plate under the transmission oil outlet.
Loosen the oil outlet plug in the warm engine. Let the transmission oil out fully
(see Fig. 15).
c. Remove the iron dust plug, this plug has a magnet on it. Iron dust caused by
moving parts will stick to the plug. Clean the iron dust from this dust plug.
d. Tighten the transmission oil outlet plug and the iron dust plug.
e. Remove dipstick of transmission (see Fig. 14), fill oil (GL-4 85W/90) about 1.9
liters.
f. Insert the transmission dipstick, check the oil level in the transmission. Confirm
the corrective oil level in the transmission (see Fig. 14).
Check transmission oil
If the color of transmission oil changes, you need to replace oil. Replace transmission
oil as above.

Engine Coolant

You must check the coolant for level and leaks. If it is low, you need to refill coolant
into the radiator (approximately 4000 ml). The lack of coolant will cause the engine to
overheat. This can cause engine damage.
The coolant should always be topped up, since the coolant can evaporate.
Figure 16
Put the vehicle on level ground.
Figure 15
Figure 17
30