Configuring The Pure Bridge Mode; Preparation - Huawei SmartAX MT880 User Manual

Service
Mode
IPoA
Note:
ISP = Internet Service Provider
IPoA = Internet Protocols over ATM
PPPoE =
PPP over Ethernet
PPPoA = PPP over ATM
Caution:
After the configuration, some configuration are validated only after it is
saved and the MT880 is rebooted. Perform this operation according to
the prompt in this configuration page.

3.3 Configuring the Pure Bridge Mode

In the pure bridge mode, the MT880 serves as a bridge. You need
to install the PPP dial-up software to realize the dial-up access to the
Internet.
This section mainly introduces how to configure the MT880 to
work in the pure bridge mode and how to configure your computer to
access the network through the MT880.

3.3.1 Preparation

Table 3-2 shows the configuration preparation.
Working Method
Take the MT880 as a router.
The MT880 uses the static public IP
address to access the Internet.
Use the IPoA encapsulation mode to
encapsulate the packets.
15
Configuration
Refer to 3.8
"Configuring the
IPoA Mode".