Docomo SH-03E Instruction Manual page 148

AT command
ATS5=<n> Sets the backspace (BS)
character.
[M]
ATS6=<n> Sets pause time (seconds) until
dialing.
[M]
ATS8=<n> Sets pause time (seconds) until
comma dialing.
[M]
ATS10=<n> Sets the delay time (seconds) for
automatic disconnection
(1/10 seconds).
[M]
ATS30=<n> Disconnects when no data is sent/
received for at least this amount of
time.
[M]
ATS103=<n> Sets delimiter used when adding
an incoming sub-address to
number dialed.
[M]
ATS104=<n> Sets delimiter used when adding
an outgoing sub-address to
number dialed.
[M]
AT¥S Displays current command and
S register settings.
[M]
AT¥V<n> Selects response code type used
during connection.
[M]
*1 Stored in FOMA terminal's memory using AT&W commands.
*2 Not stored in FOMA terminal's memory using AT&W commands. Not reset with AT&F or ATZ commands.
*3 Perform Redial with ATDNo or ATDLo.
*4 If the ATZ command is executed before the AT&W command is used, terminal settings return to last written
memory, and prior changes are erased.
*5 Settings written into the FOMA terminal's memory using the AT&W command is stored as non-volatile data
when power is turned off.
Overview
When detected while entering an AT
command, the last character in the input
buffer is deleted. The settings cannot be
changed (default setting: n=8).
Sets a register, but has no other effect.
n : 2 to 10 (default setting: n=5)
Sets a register but does not affect the pause
time (3 seconds).
n=0 : Does not pause
n : 1 to 255 (default setting: n=3)
Sets a register, but has no other effect.
n : 1 to 255 (default setting: n=1)
*1
Only valid during 64K data communication.
<n> is set in minutes.
n : 0 to 255 (default setting: n=0)
n=0 sets inactive timer off.
Only valid during 64K data communication.
n=0 : *Asterisk
n=1 : /Slash (default setting)
n=2 : ¥Yen mark or backslash
Only valid during 64K data communication.
n=0 : #Pound sign
n=1 : %Percent symbol (default setting)
n=2 : &Ampersand
*2
―
Only valid when the ATX<n> command
*1
(nP. 36) setting is not n=0.
n=0 : Does not use extended result codes
n=1 : Uses extended result codes
Parameter/Explanation
(default setting)
37
Execution
example
ATS5=8o
OK
ATS5?o
008
OK
ATS6=10o
OK
ATS8=3o
OK
ATS10=1o
OK
ATS30=3o
OK
ATS103=0o
OK
ATS104=0o
OK
AT¥So
E1 Q0 V1 X4
&C1 &D2 &S0
&E1 ¥V0
S000=000
S002=043
S003=013
S004=010
S005=008
S006=005
S007=060
S008=003
S010=001
S030=000
S103=001
S104=001
OK
AT¥V1o
OK