Sony PDW-75MD Instructions For Use Manual page 94

Alarm message in monitor
video section
DURATION OF ONE
CLIP LIST MUST BE
LESS THAN 24 HOURS.
NO MORE SUB CLIPS
CAN BE ADDED TO
THE CLIP LIST.
SUB CLIP DOES NOT
EXIST.
CLIP LIST DOES NOT
EXIST.
MOVE IS INVALID.
REC INHI!
DISC FULL!
SHOT MARK DOES NOT
EXIST.
REC START CANNOT
BE DELETED.
CLIP IS LOCKED.
ALL CLIPS ARE LOCKED.
ALL CLIPS ARE
UNLOCKED.
Alarms relating to audio and video signals
Alarm message in time
data display section
a)
No INPUT!
a)
EMPHASIS!
a) Displayed only when DISPLAY CONTROL >ALARM is set to "ON".
94
Troubleshooting
Description/action
The total duration of the current clip list is greater than 24 hours.
This appears when the total duration of the current clip list exceeds the upper limit of 24 hours as
the result of a sub clip ADD operation or a TRIM operation (see page 63).
The upper limit of sub clips in the current clip list has been exceeded.
This appears when the upper limit of 300 clips in a clip list has been exceed as the result of a
sub clip ADD operation. (see page 63).
There are no sub clips in the current clip list.
This appears when an attempt is made to execute a MOVE, TRIM, DELETE, or TC PRESET
operation (see page 63) with no sub clips in the current clip list.
There are no clip lists on the disc.
This appears when an attempt is made to execute a DELETE CLIP LIST operation (see page
63) when there are no clip lists on the disc.
The sub clip cannot be moved.
This appear when an attempt is made to execute a MOVE operation (see page 63) when there
are no sub clip in the current clip list, or when there is only 1.
The disc is write protected.
This appears when an attempt is made to execute an operation that requires recording while the
disc is write protected.
The disc is full.
This appears when an attempt is made to execute an operation that requires recording while the
disc is full.
The specified shot mark has not been recorded.
This appears when an attempt is made to execute a DELETE SHOT MARK operation on a clip
when the specified shot mark has not been recorded for that clip.
REC START cannot be deleted.
This appears when an attempt is made to delete a REC START with a DELETE SHOT MARK
operation. DELETE SHOT MARK can delete only SHOT MARK1 and SHOT MARK2 marks.
The clip is locked.
This appears when an attempt is made to delete a clip, set the clip thumbnail, or delete a shot
mark when the clip is locked.
All clips are locked.
This appears when an attempt is made to execute a LOCK ALL CLIPS operation when all clips
are already locked.
All clips are unlocked.
This appears when an attempt is made to execute an UNLOCK ALL CLIPS operation when all
clips are already unlocked.
Alarm message in monitor video
section
INPUT VIDEO IS NOT DETECTED.
CHECK THE VIDEO INPUT MODE AND
SUPPLY A VIDEO SIGNAL TO VIDEO
INPUT.
INPUT AUDIO EMPHASIS IS NOT
SUPPORTED.
CHECK THE EMPHASIS OF THE AUDIO
INPUT SIGNAL.
Action
• Check the setting of V INPUT on the HOME page of
the function menu (see page 72).
• Input an HDSDI signal.
Check the emphasis of the audio input signal.