Sony PDW-75MD Instructions For Use Manual page 13

• Up to two option boards may be installed. Some
combinations are not supported.
• Option slot 1: PDBK-101
• Option slot 2: One of the PDBK-102, PDBK-103, and
PDBK-104 boards
PDBK-101 Network Board (Gigabit
Ethernet)
Installation of this board provides a gigabit Ethernet
connector, which can be used to transfer disc files over
LAN networks and to record MXF (Material eXchange
Format) files from external devices to discs.
It also allows this unit to be controlled remotely by FTP
commands.
PDBK-102 MPEG-TS (Transport Stream)
Input/Output Board
Installation of this board enhances the functionality of the
standard i.LINK connector, allowing it to be used as an
1)
I/O interface for HDV 1080i
signals.
HD files recorded on the disc can be converted to TS
signals compatible with the HDV1080i format for transfer
to HDV devices and HDV editors, and TS signals from
HDV devices and HDV editors can be converted to MPEG
HD compatible files for recording by this unit.
1) HDV and are trademarks of Sony Corporation and Victor
Company of Japan, Limited.
2) HDV1080i: Refers to devices compliant with the "HDV1080i Standard"
for recording HD signals on DV tape. There are 1080 effective lines.
3) TS: MPEG-2 transport streams containing MPEG video, MPEG audio,
and control information. This is the standard interface for HDV
equipment.
PDBK-103 Analog HD Input Board
Installation of this board provides analog HD component
input connectors, to enable recoding of analog HD
component input signals (RGB and YPbPr, Sync) to discs.
PDBK-104 SD Input Upconverter Board
Installation of this board provides SD input connectors to
enable input of SD signals (SDSDI and composite), which
can then be recorded on DVCAM-format discs or
upconverted and recorded on HD-format discs.
Note
This unit cannot record non-standard composite signals,
for example the output of VTRs that are not equipped with
time base correctors.
2) 3)
format compatible TS
13
Features