Search Keys - Sony PDW-75MD Instructions For Use Manual

1 Setting pad
2 THUMBNAIL key
3 CHARACTER key
4 SUB CLIP key
5 Recording/playback
control keys

6 SEARCH keys

a Setting pad
Positions on the pad correspond to functions of the main
unit, as follows.
Press the top side: M/MARK1 button
Press the bottom side: m/MARK2 button
Press the left side: </IN button
Press the right side: ,/OUT button
Press the middle: SET button
b THUMBNAIL key
This has the same function as the THUMBNAIL button on
the main unit.
c CHARACTER key
Each press of this key turns the character information
superimposed on the monitor screen on and off, or
switches to the LCD.
d SUB CLIP key
This has the same function as the SUB CLIP button on the
main unit.
Note
Pressing this key has no effect when no clip list is
registered.
e Recording/playback control keys
m PREV (previous) key:Press this to jump to the first
frame of the current clip or the previous REC START
1)
essence mark. When pressed at the first frame of the
current clip, this button jumps to the first frame of the
previous clip (if it exists).
B PLAY key: Press this to start playback. Press the STOP
key to stop playback.
M NEXT key: Press this to jump to the first frame of the
next clip or to the next REC START essence mark.
x STOP key: Press this to stop recording or playback.
1) The setting of OPERATIONAL FUNCTION >FIND MODE determines
whether the unit jumps to clips or to REC START essence marks.
When you play back clips recorded with the Clip Continuous Rec function
(see page 40), you should set this menu item to "REC START EM".
24
Names and Functions of Parts
PUSH SET
THUMBNAIL SUB CLIP
CHARACTER
PREV PLAY NEXT STOP
SEARCH
1)
f SEARCH keys
Press m to perform –5 times normal speed shuttle
playback in the reverse direction.
Press M to perform +5 times normal speed shuttle
playback in the forward direction.
Using the infrared remote commander
Before use
Pull out the insulation sheet.
To replace the lithium battery in the remote
commander
The remote commander uses a CR2025 Lithium Battery.
Do not use a battery other than the CR2025.
1
Hold down the lock lever 1, and then pull out the
battery holder 2.
2
Insert a new battery with the + symbol facing upward
(1), and then push the battery holder until it clicks
(2).
WARNING
Battery may explode if mistreated. Do not recharge,
disassemble or dispose of in fire.
Insulation sheet
2
1
Face the + symbol upward.
2
1