Table of Contents
Advertisement
a) Displayed only when DISPLAY CONTROL >ALARM is set to "ON".
During recording and editing operations
Alarm message in time
data display section
a)
Input Sig!
a)
HD 60I/30P
a)
HD 50I/25P
a)
HD 23P Disc
a)
ILL. REF!
a)
ILL. REC!
a)
ILL. PLAY!
a)
MEM. Full!
a)
MEM. Empty!
Recording
Drive Busy!
a) Displayed only when DISPLAY CONTROL >ALARM is set to "ON" or
"LIMITED".
92
Troubleshooting
Alarm message in monitor video
section
INPUT SIGNAL FREQUENCY IS NOT
THE SAME AS THE SYSTEM SETUP.
DISC CANNOT BE RECORDED. HD 60I
or HD 30P CLIP(S) EXIST.
DISC CANNOT BE RECORDED. HD 50I
or HD 25P CLIP(S) EXIST.
DISC CANNOT BE RECORDED. HD
23.98P CLIP(S) EXIST.
INPUT VIDEO SIGNAL DOES NOT
SYNCHRONIZE WITH REF VIDEO
SIGNAL.
USE COMMON REFERENCE SIGNAL
OR CONNECT RECORDER REF OUT TO
PLAYER REF IN.
ENCODING DOES NOT SYNCHRONIZE
WITH REF VIDEO.
ILLEGAL PLAYBACK.
MEMORY FULL !!
MEMORY EMPTY !!
NOW RECORDING ...
PREVIOUS CLIP HAS NOT BEEN
RECORDED ON TO THE DISC
YET.STOP RECORDING AND WAIT TILL
THE ACCESS LED TURN OFF.
b) Displayed only when DISPLAY CONTROL >ALARM is set to "ON" or
"LIMITED".
Description/action
This appears when an input signal does not match
the system frequency of this unit.
Input a signal that matches the system frequency, or
change this unit's system frequency setting (see page
26).
This appears when the system frequency of this unit
does not match that of the loaded disc.
Insert a disc that matches the system frequency, or
change this unit's system frequency setting (see page
26).
Input a reference signal synchronized with this unit's
system frequency.
Check the signals being input to this unit.
Check the disc being played by this unit.
Check the disc being recorded by this unit.
Wait for recording to finish.
This appears when a clip has been saved to this unit's
temporary memory but recording to the disc has not
been completed. Wait until recording to the disc
finishes (until the ACCESS indicator turns off).
Advertisement
Table of Contents
