Sony PDW-75MD Instructions For Use Manual page 42

To select a thumbnail image and start
playback
ACCESS
NETWORK
LOCAL
REMOTE
LEVEL
CH 1 CH 2 CH 3 CH 4
PHONES
1
Do one of the following to select the thumbnail of the
clip you want to cue up.
• Press the arrow buttons.
• Turn the jog or shuttle dial.
• Press the PREV or NEXT button: Move to the
previous or next thumbnail.
• Press the TOP (SHIFT + PREV) or END (SHIFT +
NEXT) button: Move to the first or last thumbnail.
• Holding down the SHIFT button, press the M/
MARK1 or m/MARK2 button: Display the previous
or next page.
2
Press the SET button or the PLAY button.
If you press the SET button, a still image appears
showing the first frame of the selected clip.
If you press the PLAY button, playback starts from the
first frame of the selected clip.
Note
The factory default setting for the clip thumbnail is
such that the first frame of the clip is used as the
thumbnail but you can change this setting so that any
desired frame is used as the clip thumbnail (see "To
change a thumbnail image (index picture)" (page
42)). However, clip list playback always starts from
the first frame, regardless of the thumbnail.
To change the clip information displayed in
the thumbnail list
With the thumbnail list displayed, proceed as follows.
1
Press the CLIP MENU (SHIFT + SUB CLIP) button
or the MENU button to display the clip menu.
2
Press the M/MARK1 button or m/MARK2 button to
select CLIP INFORMATION.
3
Press the SET button.
42
Playback
2
F1
F2
F3
VAR
MARK1
MENU
F4 CHAPTER
IN OUT
SUB THUMB
F5 EXPAND
SET RESET
CLIP NAIL JOG
PAGE DISPLAY
CLIP ESSENCE
MENU MARK MARK2
PREV PLAY NEXT STOP REC
SHUTTLE
KEY INHI
VARIABLE
REC
PRESET
PB
SHIFT
TOP F REV F FWD END STANDBY
1 1 1 1
A list of CLIP INFORMATION items appears.
DATE: Date and time of recording
TIME CODE: Timecode of the first frame in the clip
DURATION: Recording time
SEQUENCE NUMBER: Thumbnail sequence
number
See "To select a thumbnail image and start playback"
EJECT
(page 42) for more information about sequence
thumbnail numbers.
"TIME CODE" is selected when the unit is shipped
from the factory.
4
Press the M/MARK1 or m/MARK2 button to select an
item that you want to display as part of the clip
information, and then press the SET button.
The selected item is displayed as clip information
under the thumbnail image.
To change a thumbnail image (index
picture)
With the thumbnail list displayed, proceed as follows.
1
Press the CLIP MENU (SHIFT + SUB CLIP) button
or the MENU button to display the clip menu.
2
Press the M/MARK1 button, m/MARK2 button , </
IN button, or ,/OUT button to select SET INDEX
PICTURE.
3
Press the SET button.
"SET INDEX" appears in the upper left of the screen.
4
Select the clip whose thumbnail you want to change
(you can do this with the same operations as step 1 of
"To select a thumbnail image and start playback" (see
page 42)).
5
Press the SET button.
An enlargement of the current thumbnail image
appears.