Whistler WS1095 Owner's Manual page 59

CONFIGURATION SETTING
• Use RID Alert – Controls alert for Radio ID transmissions.
• Show VC/CC – Displays voice and control channel.
Simple Display must be unchecked. Show Radio ID
will override if available.
• Show TGID – Displays talkgroup ID. Simple
Display must be unchecked.
• Show Site Name – Displays trunking site name,
only if two or more trunking system sites are
programmed. Simple Display must be unchecked.
• CONV TGID – Displays the talkgroup ID for P25
conventional talkgroup calls. Simple Display must
be unchecked.
• CONV Radio ID – Displays the Radio ID for P25
conventional calls. Simple Display must be unchecked.
• USB CCDump – Streams ASCII Control Channel
Dump data over the USB interface for trunking
control channels.
To file – Stores ASCII Control Channel Dump
data to the SD card.
Limit 100
Trim Logs
• TG Disp – Display format for talkgroup IDs.
• M36 Stat Bits – Uses status bits to track Motorola
3600 baud trunking talkgroup calls.
• M36 ENC
• EDACS Dig
• BandPlan – Selects USA or Canada.
• FlexStep - Permits using Split channel frequency.
• EncMode – For encrypted voice calls: Noise, Silent,
or Tone.
• EncLevel – Sets the encrypted call tone level.
• DSPLevelAdapt – Controls how fast the DSP
adjusts to varying P25 levels (default: 64). Higher
values = faster rates.
• ADC Gain – Controls input signal to CODEC
(default: +0dB).
• DAC Gain – Sets output signal from CODEC,
varying the audio level of decoded digital signals
(default: +0dB).
• Location Select
• Clock Display
• Firmware Ver.
59