Mobile Operation - Whistler WS1095 Owner's Manual

MOUNT INSTALLATION

Mobile Operation

By attaching the mounting bracket above the radio,
you can mount the radio underneath your vehicle's
dashboard, or in any other mounting location where the
radio will be suspended from above. You may also use
the mounting bracket beneath the radio, which makes it
possible to mount the radio on top of any flat surface in
your vehicle.
Select a mounting location that does not interfere
with visibility while driving. Use caution to select a
location that will not interfere with the deployment of
your vehicle's air bags. It is extremely important not to
mount this or any other equipment in locations where
deployment of the air bags may cause the equipment
to be propelled towards the vehicle's passengers. If
necessary, seek advice from your automotive dealer or
service shop.
Use the mounting bracket as a template to mark the
locations for the two mounting screws. At the marked
locations, drill holes that are slightly smaller than the
screws. Use caution not to damage wiring or components
that are located behind the mounting surface. Using the
provided screws and lock washers, attach the mounting
bracket to your vehicle.
Attach the two self-adhesive rubber washers to the
inside of the mounting bracket sides, over the holes that
are used when attaching the bracket to the scanner's
side holes. The rubber washers help protect the
scanner's case from scratches.
Slide the scanner into the mounting bracket assembly,
and use the two provided knurled knobs to secure the
scanner within the mounting bracket.
Connect the supplied DC power cable to a power
source in your vehicles as follows:
Disconnect the cable from the negative (-) terminal
of your vehicle's battery prior to attempting any
connections to your vehicle's electrical system.
24