Attaching Remote And Base Unit - Whistler WS1095 Owner's Manual

ATTACHING REMOTE AND BASE UNIT

Detaching and Attaching Remote
Head and Base Unit
To detach the (Remote Head Unit) from the (Base Unit),
turn the scanner off then press and hold the release
button on the left side of the base unit. A gap will
appear between the base unit and the remote head
unit. Grasp the remote head and carefully remove it
from the base unit.
To link the base unit and remote head unit, connect
them using the supplied 8P8C Type B Straight Cable.
To reattach the remote head to the base, unplug the
LAN cable from both units and align the guide pins
on the right side of the remote head with the slots on
the base unit. Then, carefully press the remote head
into the base unit, keeping your fingers out of the gap
between the remote head and the base. The magnets
will "grab", holding the remote head in place. The
remote head unit can be attached to an AMPS mount
(not included) if desired.
Base Unit
Remote Head
Press Here
WARNING: Always install the remote head with care,
keeping your fingers clear; the magnets are very
powerful. Always keep the magnets well away from
persons wearing electrical medical devices such as
pacemakers, as the magnets may cause the devices to
malfunction, endangering the wearer's life.
12