Time Display - Whistler WS1095 Owner's Manual

Time Display

The WS1095 can display a clock when the scanner is
off; by default this feature is disabled.
To enable or disable the time display:
1. From the Main Menu, select Settings to enter the
WS1095's Setting.
2. Scroll to Clock Display then press the /II/SEL key
to turn on or off. (Check mark will be displayed,
indicating the clock will be on.)
3. Press the Menu key and then the /II/SEL key to
confirm your choice.
NOTE: If you mount the scanner in your vehicle and
time display setting is enabled, the scanner will draw
power from the vehicle's battery even when turned
off. We recommend that you disable the time display
function if you mount the scanner on your vehicle.
If the internal keep-alive batteries are allowed to fully
discharge, the date and time will need to be set again.
If this occurs, recharge the internal batteries using one
of the following methods.
• Plug in the AC power adapter, then power on the
scanner for one hour.
• Or connect the scanner's USB jack to your PC's
USB port; leave the scanner power off. Charging
Backup Battery appears on the display. After 1 hour,
disconnect both USB connectors.
NOTE: The scanner does not function on USB bus
power only.
TIME DISPLAY
46