Maytag W10240878A Use & Care Manual page 11

C ii:ii_ ,iii!!ii_ _iJil ¸¸ i_i_ _!ii_i iii i_i_i_ ¸:ii,_ i!!i!il li: I '_i_i_ e ;¢, _ ii:_ _:: o
IMPORTANT." Your dryness [eve[ settings can be adjusted to adapt
to different installations, environmental conditions, or persona[
preference. This change is retained and will affect all of your Auto
Cycles, not just the current cycle/load.
If all your loads on all Auto Cycles are consistently not as dry as
you would like, you may change the default settings to increase the
default dryness [eve[. This change will affect all of your Auto Cycles.
There are 3 drying settings, which are displayed using the WET,
DAMP, and COOl. DOWN indicators:
more (_
time
less
time
[]
wrinkle
prevent
1. (factory preset dryness level) - WET indicator lit.
2. (slightly drier clothes, 15% more drying time) - WET and DAMP
indicators lit.
3, (much drier clothes, 30% more drying time) - WET, DAMP, and
COOl. DOWN indicators [it.
To change the Dryness Level settings:
NOTE: The Dryness I.eve[ settings cannot be changed while the
dryer is running.
1. Press and hold the TEMPERATURES button for at least
6 seconds. The dryer will beep, and the current drying mode
will be displayed.
2. To select a new drying setting, press the TEMPERATURES
button again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting
will be [it solid, but the other settings will flash.
3,
4,
Press the START/PAUSE button to save the drying setting and
exit to standby mode.
NOTE: To exit without saving, press the POWER/CANCE[ ....
button.
The drying setting you selected will become your new preset
drying setting for all Auto Cycles.
options and modifiers p,o,,_,o_dtO_ockiooto,, __
controls
11