Before Requesting Service - A&D TM-2657P Instruction Manual

12.7. Before requesting service

Before requesting service, please see the following checklist and the error code list in the next
section.
Problem
Nothing is displayed
Is the power cable connected
when the power is
correctly?
switched on.
E00 is Is there air remaining in the
displayed. cuff?
There is no Is the arm cuff cover pulled
pressure. too far over the frames?
Is the patient's posture
correct?
Measurement is Is the patient relaxed?
not possible.
(An error code is
―――――――――
displayed.)
―――――――――
The printer paper is not
installed. (
The printer cover is open.
(
No printing
A printer cutter error. (
displayed)
Is the printer paper causing a
jam?
The printing
Is the printing method
content was not
selection appropriate?
as expected.
Check the clock setting.
Is the Low Battery printed on
Date and/or time
the lower left of the print out
are off.
after the count graph is
printed as shown in 12.5.2?
Do not touch the interior of the monitor.
Check
is displayed)
is displayed)
is
Countermeasure
Connect the power cable correctly.
Wait until the air is released completely from the
cuff, and then switch the power on again.
See "12.4. Replacing the arm cuff cover" to reattach
the arm cuff cover correctly.
Ensure that the arm and heart are at the same height
and that the patient is relaxed.
Ensure that the patient does not move their arm.
If clothing is too thick, measurement is not possible.
Remove the clothing from the arm.
Measurement may not be possible with patients with
arrhythmia or a weak pulse.
See "9.1. Installing the printer paper" to install a new
roll of printer paper.
See "9.1. Installing the printer paper" to close the
printer cover.
See "9.1. Installing the printer paper" to temporarily
open the printer cover and then close it again.
See "9.1. Installing the printer paper", readjust the
paper.
See Sections "10.4. IHB" to "10.10. Bitmap
printing" to select the printing method.
Refer to "8.SETTING THE CLOCK"
A lithium battery for back up settings and other data is
empty. Contact the local A&D dealer.
Caution
45