Pre-Inspection; Introduction; Before Switching The Power On; After Switching The Power On - A&D TM-2657P Instruction Manual

6.5. Pre-inspection

Perform the pre-inspection everyday to ensure safe and correct usage.
■
6.5.1.

Introduction

Before using the monitor for the first time each day, perform the following pre-inspection.
6.5.2.

Before switching the power on

Is there any external deformation or damage to the monitor?
Is the monitor wet?
Is the monitor in a stable location free of tilting, vibrations and impacts?
Blood pressure measurement section
Is there damage or problems around the arm insertion section (cuff area)?
Is the arm cuff cover attached?
Is the arm cuff cover stretched too much?
Connection cable
Are the optional cables inserted firmly into the connectors of the monitor?
Power cable
Make sure that the electrical outlet is properly grounded and supplies the specified voltage
and frequency (100-240V~ 50-60 Hz).
6.5.3.

After switching the power on

Is there any smoke or strange smell?
Can you hear any strange noises?
Checking the time
Is the time set correctly?
If the time is incorrect when recording data, the data will be incorrect.
Checking the display
After switching the power on, all LEDs switch on for
several seconds
measurement is possible. At this time, the diastolic
blood pressure display displays "0".
Warning
and then blood pressure
13
SYS mmHg