Checking The Number Of Measurements - A&D TM-2657P Instruction Manual

12.5. Checking the number of measurements

The monitor can count the number of times blood pressure measurement has been performed.
This function is designed to check usage frequency and provide a reference for scheduled
cleaning. The count value is stored even after the power is switched off.
12.5.1.
Displaying the number of measurements
To display the number of measurements:
Hold the COUNT button for 1 second while the monitor is in the
standby mode. The number of measurements is displayed for
about 60 seconds in the systolic and diastolic display sections.
In the example display below, the number of measurements is
2,382. (The maximum count is 999,999.)
SYS mmHg
DIA mmHg
PUL /min.
To reset the number of measurements:
Hold the ▲ button for 4 seconds to
display the reset confirmation display.
Press the START/STOP button to
reset the count.
12.5.2.
Printing the count graph
To print the count graph:
Press the COUNT button. While the number of measurements is
displayed, press the START/STOP button to print the count graph.
Total Count: Number of measurements since shipping
Trip Count: Number of measurements since the last
reset (See "12.5.1. Displaying the number of
measurements")
Weekly Count: A distribution of the number of measurements
in the last week.
Monthly Count: A distribution of the number of measurements
in the last month
F07
If the function
After the count graph is printed, the number of measurements remains displayed for about 60
seconds.
If the "Low Battery" is printed in the lower left of the print out after the count graph is printed
out, please contact the local A&D dealer.
is set to off, the count graph is not printed. (See "10.5. Print quality")
SYS mmHg
DIA mmHg
PUL /min.
Note
43
SYS mmHg
DIA mmHg
PUL /min.