A&D TM-2657P Instruction Manual page 6

4. After using the monitor.
Use the specified procedure to return switches to their state before usage, and then
switch the power off.
Do not forcibly pull out the cables. Hold the connector with your hand when disconnecting
the cables.
Clean the accessories and arrange them before storage
Keep the monitor clean and in proper operating condition so that it can be used without
problem for the next operation.
5. If you suspect there is a problem with the monitor, perform the following actions.
Ensure the safety of the patient.
Stop the operation of the monitor, switch the power off, and then disconnect the
power cable from the outlet.
In an emergency, such as when the air in the cuff is not released by pressing the
START/STOP switch, press the FAST STOP switch.
Label the monitor with a sign that says "Out of order" or "Do not use" and then
contact A&D immediately.
6. When performing a maintenance inspection.
For your safety, before performing a maintenance inspection, switch the power off
and disconnect the power cable from the outlet.
If the monitor has not been used for an extended period, check that the monitor
operates normally and safely before using it.
Always perform a pre-inspection and maintenance inspection to ensure safe and
correct operation. The organization that installs the monitor (hospital, clinic) is
responsible for use, maintenance, and management of medical electrical devices.
Neglecting pre-inspection and maintenance inspection can result in accidents.
Never disassemble or modify the monitor (medical electrical device).
When maintaining the monitor, use a dry, soft cloth. Do not use rags soaked in
volatile liquids such as thinner and benzene.
Caution
.
Warning
Warning
Caution
iv