SOYO SY-K7V DRAGON Plus! User Manual page 194

When I boot up my new computer I got "floppy boot failure" and the
LED on the floppy stays on
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy
drive side (don't trust the "key lock" or "notch") and use the end-connector
of the cable (don't use middle one).
RAID issue
Windows do not detect the on-board RAID.
Enable the on-board RAID function in the BIOS.
Can I use my CD-ROM on IDE 3 & 4?
Yes, you can use the CD-ROM on IDE 3 & 4.
Can I use IDE 3 & 4 to boot from CD-ROM?
No.
Can I use IDE 3 & 4 as a normal IDE channel?
Yes, no need to change any settings in the BIOS.
I cannot get the HDD to boot from IDE 3 or IDE 4, why?
st
Make sure that the 1 boot device in the BIOS is set to SCSI.
USB Issues
Can I use USB port 3_4 and port 5_6 for keyboard resume function?
This M/B has 6 USB ports, but only the 2 at the back panel can be used for
USB keyboard resume function.
I cannot get my USB working, help!
Please check if the system performance setting in the BIOS is set to maxium
/Turbo, if yes, then enable the USB by setting the system performance to
normal or manually enable the USB port (on-chip USB controller under
Integrated Peripherals).
LAN Issues
During LAN driver installation, the system hangs on 75%, why?
Enable the onboard LAN in the BIOS setup.
For updated FAQs, please check http://www.soyo.com.tw/faq.htm or
http://www.soyousa.com/faqs.html
190