SOYO SY-K7V DRAGON Plus! User Manual page 157

single drive spanned (JBOD). Multiple drives striped or spanned will not
work. Also, the controller must address the drives as LBA, not CHS.
Q: If I have a problem with one of the drives on the FastTrak100-Lite,
how can I low level format it to correct the problem?
A: Do NOT do this. Low-level formatting IDE drives is unnecessary and
generally does not correct problems which might be experienced during
use. Errors such as bad sectors or ECC/CRC failure are best remedied
by completely replacing the drive. For this reason, drives attached to the
FastTrak100-Lite controller should NOT be low level formatted.
Q: Do I have to install disk management software on my array in order
to access the full storage capacity of drives?
A: No! Disk management software would only complicate things. The array
should be fully addressable by your O/S as it is. Remember that some
operating systems have varying limits on the sizes of partitions and
logical drives that can be defined. Consult your O/S documentation
about partitioning larger drives.
Q: What system BIOS CMOS settings do I use for the drives on the
FastTrak100-Lite controller?
A: None. The drives on the FastTrak100-Lite controller are supported by
the FastTrak100-Lite BIOS and/or an O/S drivers, not by your system
BIOS.
Q: How do I partition/format my FastTrak100-Lite RAID array?
A: The FastTrak100-Lite "fools" the system into thinking that it's dealing
with a single HDD. Therefore, anything that you can do to a single HDD
can also be done to a FastTrak100-Lite array. You can, and should, use
the FDISK and FORMAT utilities to partition/format the array. You can
partition the array however you see fit. You can format the array with
whatever file system you wish.
153